When you get the mural, make sure the strips are complete, it's related to the matching the different strips later on.
1. Wall cleaning: Fill in all cracks or holes. Polished wall with fine sandpaper and use a sponge to clean dust dirt or grease on the wall.
2、Creat a plumb line: Use a tape measure or spint level to mark the vertical line for the first part.
3、Use a scraper: Peel off the backing paper, Use a scraper to install the first mural from top to bottom by vertical line and smooth out any air bubbles from the middle to both sides. Note: reserve 1 inch mural on the left when installing the first panel. After you finish it cut off the excess parts.
4、Install the next panel: Match out the subsequent parts by sliding into place.
5、No overlapping: Match the edge of the previous part directly according to the pattem. Until the perfect seamless stitching. Continue to install each panel as you go.
Notice: installing nearth power switch. you can cut the diagonal of the power switch similar to "X", and cut off the excess part.